Here’s  a song I’ve made with the volca bass and keys, https://soundcloud.com/johaneckerstrom/house-of-missiles.

The bass sound is actually programmed in Step Mode as a simple pattern in 1/16 notes, and then resampled a few times with different manually movements. There are not many effects on the bass, just a multiband compressor and a little Haas for stereo width. (Then of course side-chain, triggered by the kickdrum.)

Breakdown

The bass sound is made on the volca bass. First group all three VCOs together (VCO GROUP) and turn them on (VCO1, VCO2 and VCO3 lit). Leave PITCH 2 off but detune PITCH 1 (down) and PITCH 3 (up) for a thick unison effect. Have the first (VCO1) and second (VCO2) oscillators generate a sawtooth wave and the third a square wave (VCO WAVE).

On the low-pass filter section (VCF) you’ll need a little resonance to make the LFO go well into audio range, so put PEAK level on 11 o’clock.

Set CUTOFF frequency at 11 o’clock. (As for knob movement, slightly raise CUTOFF level at the same time as EG DECAY/RELEASE drops.)

Now, set the LFO RATE to max and TARGET to CUTOFF modulation. Adjust intensity (INT) to 9 o’clock or so. This little trick – modulating the filter cutoff point (or pitch) with an audio range oscillator – introduces some buzz or grit (read: distortion) to the sound. And if you turn down the intensity a bit, you will get a fat analog sound.

Turn on the envelope generator for volume (AMP EG ON). On the EG section, set ATTACK to null, DECAY/RELEASE to 1 o’clock – turn this knob to about 10 o’clock and back again – and CUTOFF EG INT to 10 o’clock.

Problems

There were two technical problems with recording the volca modules: first MIDI latency and second, mono recording.

I’ve spent an hour or two trying to solve the MIDI offset, but didn’t succeed. In the end I just ignored it. (Well, someday I will fix it, for sure.)

And about the mono recording. The volca modules (bass and keys) are each a 3 VCO strong monosynth, and both of them have a stereo audio output. I can’t make much sense of this, but I could connect the each device to (A) a mono or (B) a stereo pair input on the audio interface (Propellerhead Balance). I chose to mono to save input ports. Moreover, I’ve read somewhere that the so called stereo, is just one mono signal rendered as left and right. This might be wrong though.

Advertisements